The five basic types of door bottoms
- The Slide-on The easiest to install. Slide off the old sweep, slide on the new.
- The snap-in Can normally be installed without removing the door. They fit into a kerf cut in the bottom of the door.
- The wrap-around Easy to install and are adjustable but sometimes requires installing new holes in the door.
- The ?L? shape Screws to the inside surface of the door. Easy to install and adjust, but don?t always work well
- The staple-on Requires removing the door from the frame. This type of door bottom is generally found on wood doors.
Determine Type of Door Bottom or Sweep:
Steel and Fiberglass doors normally use the slide on or snap in type. Benchmark steel doors use a ?L? Shaped bottom. Peachtree are a heavy rubber that is fitted into the bottom of the door. Wood doors are almost always a nail or staple-on type door sweep. The wrap-around and ?L? Shaped door bottoms are screwed into the inside surface of the door. Remove the screws and the door bottom comes off.
Slide-on Door Bottoms or Sweeps:
- Determine which door bottom is needed. The slide-on have different designs.
- Remove the existing door bottom, most just slide off.
- Cut new sweep to length if needed, Slide on new door sweep.
- If door sweep fits to loosely a spot of adhesive or caulk may be applied between sweep and bottom of door.
Snap-in Door Bottoms or Sweeps
- Determine which door bottom is needed. The Snap in door bottoms have different designs and sometimes even the heights of the door sweeps will vary. Most of these type of door bottoms have a single or double kerf cut in the bottom of the door for the sweep to lock into. The spacing of the kerfs vary and you will want to match profiles.
- Remove the existing door bottom. Most just pry off.
- Cut new door sweep to length if needed. Snap or push new door sweep onto bottom of door.
- If sweep fits to loosely a spot of adhesive may be applied.
Wrap-Around or ?L-Type? Door Bottoms / Sweeps
- Determine which door bottom is needed. The Wrap-around fit different thickness of doors. most exterior doors are 1-3/4? thick. Some older homes have doors that are 1-3/8? up to 2-1/4? thick.
- Remove the screws on the existing door bottom.
- Cut new door bottom to length if needed. Position new door bottom onto bottom of door.
- Close door and adjust door bottom as need to get proper fit.
- Apply new screws to hold door bottom in place. Be careful not to fit the sweep to tightly. If there is too much pressure on the bulbs or fins it will wear out faster.
Staple-on Door Bottoms or Sweeps
- Determine which door bottom is needed. The Staple-on have different designs and even the heights of the door sweeps will vary. The goal is to match profiles; especially height.
- Remove the Hinge Pins from the Door. Lay door on its edge. Be careful not to position the door where it can fall or become scratched.
- Cut new sweep to length if needed. Position new onto bottom of door. Note: The staple-on door bottom may seal better if a small spot of adhesive or caulk is applied to the bottom of the door before installing. Use just enough to touch both surfaces.
- Staple from the center and work your way to both ends. This will reduce the likely hood of ripples in the door bottom when applied. It is also best if the staples are staggered to both the inside and outside of the door sweep.
- Re-install door. Note: If replacing door by yourself, be careful not to hurt yourself. Some wood doors are very heavy. The use of shims under the door may help with alignment when connecting hinges.
